Yellow LED-light | Green LED-light | Red LED-light | |
When the device switched ON | The light flashes = The device is searching for network and satellites The light stays on: Wait (the device could be e.g. installing an update) If the light turns red: Send the device to Service | If this happens when the device is switched ON or while it's in use: The light stays on = Fault condition -> Wait If the situation does not change: Restart the device If restarting did not help: Send the device for Service | |
While the device is in use Cyan LED-light: When VoiceClip is recorded White LED-light: Safety-light is activated | The light flashes = The device is downloading data (e.g. AGPS or a firmware update) The device is in normal operating mode The light stays on = Wait (the device could be e.g. installing an update) | The light flashes = The device has found network and satellites The device is in normal operating mode | |
When the device is switched OFF | The device is not in fault condition! The light starts flashing = When You keep holding the power switch down the device will eventually switch off When the light stays on = You can release the power switch for the device is now SWITCHED OFF | ||
While charging the device | The light flashes = The device's battery is charging Note! Bring the device to a warm location for charging and allow it to warm up for a while before connecting it to the charger | The light stays on = The device's battery is fully charged to 100% 1. You can disconnect the device from its charger 2. All 3 LED-lights on the device stays on for a moment and then turns off Note! If the device is not used for a long time, fully charge the battery first | The light flashes = Fault condition 1. Check charger and charging cable 2. Disconnect the charger from the wall outlet and the device from the charging cable 3. Wait a few minutes and then reconnect the charger and charging cable 4. If possible, test with another charger 5. If the situation does not change: Send the device for Service |